How to Factory Reset the TWS106

Categories

Go to the full support page of the related products: TWS106

Step 1. Put both earbuds back into the charging case.

Step 2. Press & hold both buttons for about 8s, until the LED flashes BLUE 3 times then turns off.

Step 3. Remove both earbuds from the case, keeping them close together so they connect to each other. When complete, the LED on the RIGHT earbud should flash BLUE faster than the LEFT earbud.

Step 4. Earbuds are now reset. Before re-pairing them to your device again, turn on your device's Bluetooth settings:

*Make sure to remove previous Avantree TWS106R and Avantree TWS106L profiles

Related knowledge:
1. Bluetooth device normally auto-reconnects to its LAST paired / connected device. You might need to make sure the previous used device are Bluetooth-off to avoid interference.
2. It is important to Reset both Bluetooth sender and receiver. In case of cellphone / PC, you can turn off its Bluetooth function and turn it back on.
3. If still not working, you can email us (support@avantree.com) or simply show up online in our twice daily live Zoom Clinic. We will help you to fix it.

Session 1
Zoom Link - https://us02web.zoom.us/j/6557062216
Time: 9-10AM Easter Time || 1-2PM Greenish Mean Time || 2-3PM Frankfurt Time

Session 2
Zoom link - https://us02web.zoom.us/j/6855732479
Time: 11AM-12PM Pacific Time || 2-3PM Eastern Time || 7-8PM Greenish Mean Time || 8-9PM Frankfurt Time

Go to full product support page of [TWS106]

Was this answer helpful?

Views

TOP