How to factory reset / clear pairing history of HT4106?

TWS106:

Step 1. Put both earbuds back into the charging case.

Step 2. Press & hold both  buttons for about 8s, until the LED flashes BLUE 3 times then turns off.

Step 3. Remove both earbuds from the case, keeping them close together so they connect to each other. When complete, the LED on the RIGHT earbud should flash BLUE faster than the LEFT earbud.

Step 4. Earbuds are now reset.

Audikast Plus:

Step 1: Power on the Audikast Plus

Connect the Audikast Plus to power, and flip the power switch to “ON”.

Step 2: Factory Reset

Press & hold the "+" and "-" buttons simultaneously for 7 seconds. You'll see both Bluetooth LED indicators light up PINK and turn off, indicating that the reset was successful.

Once this is done, the Audikast Plus will re-enter pairing mode, as indicated by the Bluetooth icon next to "A" flashing RED & BLUE.

Related knowledge:

1. Bluetooth device normally auto-reconnects to its LAST paired / connected device. You might need to make sure the previous used device are Bluetooth-off to avoid interference. 

2. It is important to Reset both Bluetooth sender and receiver. In case of cellphone / PC, you can turn off its Bluetooth function and turn it back on. 

3. If still not working, you can email us (support@avantree.com). We will help you to fix it.